/* [<][>][^][v][top][bottom][index][help] */
#ifndef __LINUX_SPI_DS1305_H
#define __LINUX_SPI_DS1305_H
/*
* One-time configuration for ds1305 and ds1306 RTC chips.
*
* Put a pointer to this in spi_board_info.platform_data if you want to
* be sure that Linux (re)initializes this as needed ... after losing
* backup power, and potentially on the first boot.
*/
struct ds1305_platform_data {
/* Trickle charge configuration: it's OK to leave out the MAGIC
* bitmask; mask in either DS1 or DS2, and then one of 2K/4k/8K.
*/
#define DS1305_TRICKLE_MAGIC 0xa0
#define DS1305_TRICKLE_DS2 0x08 /* two diodes */
#define DS1305_TRICKLE_DS1 0x04 /* one diode */
#define DS1305_TRICKLE_2K 0x01 /* 2 KOhm resistance */
#define DS1305_TRICKLE_4K 0x02 /* 4 KOhm resistance */
#define DS1305_TRICKLE_8K 0x03 /* 8 KOhm resistance */
u8 trickle;
/* set only on ds1306 parts */
bool is_ds1306;
/* ds1306 only: enable 1 Hz output */
bool en_1hz;
/* REVISIT: the driver currently expects nINT0 to be wired
* as the alarm IRQ. ALM1 may also need to be set up ...
*/
};
#endif /* __LINUX_SPI_DS1305_H */